Flame–wall interactions of lean premixed flames under elevated, rising pressure conditions. (1st February 2017) - Yenerdag, Basmil
Highlights: Flame–wall interactions of hydrocarbon flames are studied using 1D DNS. Flame–wall interaction time can be scaled by flame time at fixed wall temperature. Effects of pressure increase on flame–wall interaction time are insignificant. Effects of LTHR in n -heptane flames on wall heat flux are insignificant. Abstract: Direct numerical simulation (DNS) of laminar lean methane–air and n -heptane–air premixed flames with high exhaust gas recirculation (EGR) ratios propagating towards inert walls in a head-on quenching configuration is conducted to investigate flame–wall interactions at relatively high initial pressure conditions. This study considers the flame propagation under isochoric process after ignition while the piston is at top dead center (TDC). The effects of EGR ratio, equivalence ratio, initial pressure and wall temperature on heat loss and quenching distance are investigated. The results showed that change of EGR ratio in fuel mixture significantly affects the maximum wall heat flux and the heat flux induced by the burned gas temperature. The normalized flame–wall interaction time is not influenced over a range of EGR ratios, equivalence ratios and initial chamber pressures for methane–air and n -heptane–air flames at fixed wall temperature conditions. The dimensional flame–wall interaction time is almost constant when the chamber pressure is doubled. The influence of low temperature oxidation in n -heptane flames on wall heat flux induced by temperature differences between the preheated fuel mixture and the wall is found to be insignificant. Moreover, both thermal conductivity near the wall and quenching distance are sensitive to the wall temperature, and have a substantial influence on the wall heat flux.