Performance enhancement of thermoelectric waste heat recovery system by using metal foam inserts. (15th September 2016)

• Record Type: Journal Article
• Authors: Wang, Tongcai; Luan, Weiling; Liu, Tongjun; Tu, Shan-Tung; Yan, Jinyue
• Is Part Of: Energy conversion and management. Volume 124(2016)
• Page Start: 13
• Page End: 19
• Publication Date: 2016-09-15
• Subjects: Waste heat recovery -- Thermoelectric generator -- Heat exchanger -- Metal foam; Direct energy conversion -- Periodicals; Energy storage -- Periodicals; Energy transfer -- Periodicals; Énergie -- Conversion directe -- Périodiques; Direct energy conversion; Periodicals; 621.3105
• DOI: 10.1016/j.enconman.2016.07.006
• Languages: English
• ISSNs: 0196-8904

Abstract

Highlights: A type of metal foams filled thermoelectric waste heat recovery system was proposed. Metal foams were demonstrated to effectively enhance TEG performance. Three kinds of metal foam inserts were experimented and compared, respectively. Waste heat recovery rate was proposed to assess the energy efficiency of the system. Abstract: This paper proposed a type of metal foams filled thermoelectric generator (TEG) for waste heat recovery. Metal foam inserts of three kinds of pore densities (5 PPI, 10 PPI and 20 PPI) were included, considering the heat transfer enhancing features of porous metal mediums. A flow channel detachable prototype was designed to experimentally investigate the influence of metal foams on the performance of thermoelectric waste heat recovery (TWHR) system. The operating parameters were further experimented to improve the thermoelectric power generation efficiency, including hot air inlet temperature, cold water flow rate, metal foam pore density and thermoelectric module (TEM) connecting mode. Moreover, the TWHR performance of the system was evaluated on power generation efficiency, heat exchange effectiveness and waste heat recovery rate, respectively. The results showed that filling metal foams in the flow channels could effectively enhance the performance of the TWHR system. The maximum power generation efficiency was 2.05%, when the TEG was filled with 5 PPI metal foams. It was 29.75% higher than the value of unfilled TEG.