Influence of praseodymium content and postdeposition annealing on the structural and sensing characteristics of PrTixOy sensing films using the sol–gel spin-coating method. Issue 31 (19th July 2016)

• Record Type: Journal Article
• Authors: Pan, Tung-Ming; Tan, Chia-Ying
• Is Part Of: Journal of materials chemistry. Volume 4:Issue 31(2016)
• Page Start: 7436
• Page End: 7442
• Publication Date: 2016-07-19
• Subjects: Materials -- Periodicals; Chemistry, Analytic -- Periodicals; Optical materials -- Research -- Periodicals; Electronics -- Materials -- Research -- Periodicals; 543.0284
• DOI: 10.1039/c6tc02863b
• Languages: English
• ISSNs: 2050-7526

Abstract

Abstract : In this paper, we developed a low-cost, simple and rapid fabrication method for a PrTi x O y electrolyte–insulator–semiconductor (EIS) sensor using the sol–gel spin-coating technique. Abstract : In this paper, we developed a low-cost, simple and rapid fabrication method for a PrTi x O y electrolyte–insulator–semiconductor (EIS) sensor using the sol–gel spin-coating technique. The influence of praseodymium content and postdeposition annealing on the structural and sensing properties of PrTi x O y sensing membranes was investigated. X-ray diffraction, atomic force microscopy, and X-ray photoelectron spectroscopy were used to investigate the structural, morphological and chemical features of these films, respectively, as functions of the growth conditions (Pr concentrations ranging from 0.1 to 0.3 M; temperatures ranging from 700 to 900 °C). The observed structural properties were then correlated with the resulting pH sensing performances. The PrTi x O y EIS device prepared under a Pr concentration of 0.2 M, with subsequent annealing at 800 °C, exhibited the best sensing characteristics, including pH sensitivity, hysteresis and drift. We attribute this behaviour to the optimal praseodymium content and annealing temperature in this sensing film forming a well-crystallized Pr2 TiO5 structure and a rougher surface.