Application of acoustic emission sensor to investigate the frequency of tool wear and plastic deformation in tool condition monitoring. (October 2016)

• Record Type: Journal Article
• Authors: Bhuiyan, M.S.H.; Choudhury, I.A.; Dahari, M.; Nukman, Y.; Dawal, S.Z.
• Is Part Of: Measurement. Volume 92(2016)
• Page Start: 208
• Page End: 217
• Publication Date: 2016-10
• Subjects: Tool condition monitoring -- Tool wear -- Plastic deformation -- Acoustic emission -- Signal frequency; Weights and measures -- Periodicals; Measurement -- Periodicals; Measurement; Weights and measures; Periodicals; 530.8
• DOI: 10.1016/j.measurement.2016.06.006
• Languages: English
• ISSNs: 0263-2241

Abstract

Highlights: The process of tool wear in turning has been replicated by material removal in grinding. The AE signal frequency of tool wear has separated from plastic deformation frequency. The amplitude of AE signal increases with the increase of tool wear. The frequency of AE signal increases with the increase of material removal. Abstract: The metal cutting process initiates with the occurrence of plastic deformation of workmaterial and is followed by tear and removal of material from the workpiece. This process ultimately damages cutting tool and causes tool wear. An acoustic emission (AE) sensor has been employed to measure the signal frequency in machining. The AE signal component of tool wear and plastic deformation in turning are separated by simulating the process of tool wear by a grinding test where the workpiece of grinding test is the same tool-insert for tuning test, and the process of tool wear in turning is replicated by the process of material removal in grinding. The frequency of tool wear for this particular investigation is found to lie between 67 kHz and 471 kHz whereas for plastic deformation of workmaterial, it has a fluctuation within the range starting from 51 kHz to some value within 471 kHz.