A simple and rapid electrochemical sensing method for metribuzin determination in tap and river water samples. Issue 12 (10th March 2016)

• Record Type: Journal Article
• Authors: Stojanović, Zorica; Đurović, Ana; Kravić, Snežana; Grahovac, Nada; Suturović, Zvonimir; Bursić, Vojislava; Vuković, Gorica; Brezo, Tanja
• Is Part Of: Analytical methods. Volume 8:Issue 12(2016)
• Page Start: 2698
• Page End: 2705
• Publication Date: 2016-03-10
• Subjects: Chemistry, Analytic -- Periodicals; Analytical biochemistry -- Periodicals; Chemical laboratories -- Standards -- Periodicals; 543.1905
• DOI: 10.1039/c5ay03243a
• Languages: English
• ISSNs: 1759-9660

Abstract

Abstract : This paper describes an electroanalytical method for the determination of metribuzin using a thin film mercury electrode by chronopotentiometry. Abstract : This paper describes an electroanalytical method for the determination of metribuzin using a thin film mercury electrode by chronopotentiometry. Research included optimization of the most important parameters of chronopotentiometric analysis and the best responses were achieved in Britton–Robinson buffer at pH 5.0, using an initial potential of −0.21 V, ending potential of −1.1 V, and reduction current in the range from −4 μA to −15 μA. Under these conditions, metribuzin was reduced in an irreversible electrode reaction process with one well-defined reduction wave at −0.83 V ( vs. Ag/AgCl, KCl, 3.5 mol dm −3 ). A linear response was observed for three concentration ranges 1–5, 5–15 and 15–30 mg dm −3, with an achieved limit of detection of 0.042 mg dm −3 . The precision was determined as a function of repeatability and reproducibility, which showed relative standard deviation values not higher than 3.18%. Various interfering substances did not interfere with metribuzin determination. The proposed method was successfully applied to tap and river water samples. The recovery values obtained for spiked river water samples were in good statistical agreement with those obtained by the LC-MS/MS method. Accordingly, the proposed chronopotentiometric methodology can be conveniently applied in the quality control of environmental water samples as a simple, sensitive, reliable and low cost method.