Heat accumulation during sequential cortical bone drilling. Issue 3 (24th September 2015)

• Record Type: Journal Article
• Authors: Palmisano, Andrew C.; Tai, Bruce L.; Belmont, Barry; Irwin, Todd A.; Shih, Albert; Holmes, James R.
• Is Part Of: Journal of orthopaedic research. Volume 34:Issue 3(2016)
• Page Start: 463
• Page End: 470
• Publication Date: 2015-09-24
• Subjects: bone drilling -- sequential drilling -- heat accumulation -- cortical bone -- thermal osteonecrosis -- Kirschner wire; Orthopedics -- Periodicals; Musculoskeletal system -- Periodicals; 616.7
• DOI: 10.1002/jor.23044
• Languages: English
• ISSNs: 0736-0266

Abstract

ABSTRACT: Significant research exists regarding heat production during single‐hole bone drilling. No published data exist regarding repetitive sequential drilling. This study elucidates the phenomenon of heat accumulation for sequential drilling with both Kirschner wires (K wires) and standard two‐flute twist drills. It was hypothesized that cumulative heat would result in a higher temperature with each subsequent drill pass. Nine holes in a 3 × 3 array were drilled sequentially on moistened cadaveric tibia bone kept at body temperature (about 37°C). Four thermocouples were placed at the center of four adjacent holes and 2 mm below the surface. A battery‐driven hand drill guided by a servo‐controlled motion system was used. Six samples were drilled with each tool (2.0 mm K wire and 2.0 and 2.5 mm standard drills). K wire drilling increased temperature from 5°C at the first hole to 20°C at holes 6 through 9. A similar trend was found in standard drills with less significant increments. The maximum temperatures of both tools increased from <0.5°C to nearly 13°C. The difference between drill sizes was found to be insignificant ( P > 0.05). In conclusion, heat accumulated during sequential drilling, with size difference being insignificant. K wire produced more heat than its twist‐drill counterparts. This study has demonstrated the heat accumulation phenomenon and its significant effect on temperature. Maximizing the drilling field and reducing the number of drill passes may decrease bone injury. © 2015 Orthopaedic Research Society. Published by Wiley Periodicals, Inc. J Orthop Res 34:463–470, 2016.