High-rate activated sludge system for carbon management – Evaluation of crucial process mechanisms and design parameters. (15th December 2015)

• Record Type: Journal Article
• Authors: Jimenez, Jose; Miller, Mark; Bott, Charles; Murthy, Sudhir; De Clippeleir, Haydee; Wett, Bernhard
• Is Part Of: Water research. Volume 87(2015)
• Page Start: 476
• Page End: 482
• Publication Date: 2015-12-15
• Subjects: Activated sludge -- A-stage -- Biosorption -- Bioflocculation -- Energy -- High-rate treatment; Water -- Pollution -- Research -- Periodicals; 363.7394
• DOI: 10.1016/j.watres.2015.07.032
• Languages: English
• ISSNs: 0043-1354

Abstract

Abstract: The high-rate activated sludge (HRAS) process is a technology suitable for the removal and redirection of organics from wastewater to energy generating processes in an efficient manner. A HRAS pilot plant was operated under controlled conditions resulting in concentrating the influent particulate, colloidal, and soluble COD to a waste solids stream with minimal energy input by maximizing sludge production, bacterial storage, and bioflocculation. The impact of important process parameters such as solids retention time (SRT), hydraulic residence time (HRT) and dissolved oxygen (DO) levels on the performance of a HRAS system was demonstrated in a pilot study. The results showed that maximum removal efficiencies of soluble COD were reached at a DO > 0.3 mg O2 /L, SRT > 0.5 days and HRT > 15 min which indicates that minimizing the oxidation of the soluble COD in the high-rate activated sludge process is difficult. The study of DO, SRT and HRT exhibited high degree of impact on the colloidal and particulate COD removal. Thus, more attention should be focused on controlling the removal of these COD fractions. Colloidal COD removal plateaued at a DO > 0.7 mg O2 /L, SRT > 1.5 days and HRT > 30 min, similar to particulate COD removal. Concurrent increase in extracellular polymers (EPS) production in the reactor and the association of particulate and colloidal material into sludge flocs (bioflocculation) indicated carbon capture by biomass. The SRT impacted the overall mass and energy balance of the high-rate process indicating that at low SRT conditions, lower COD mineralization or loss of COD content occurred. In addition, the lower SRT conditions resulted in higher sludge yields and higher COD content in the WAS. Highlights: A HRAS pilot was operated under controlled conditions to evaluate the impact of SRT, DO and HRT. The removal of the sCOD fraction is difficult to control and minimize completely. SRT, DO and HRT can be used to control the removal of particulate matter in the HRAS. The SRT impacted the overall mass and energy balance of the HRAS. At low SRT, lower COD mineralization and higher sludge yields and COD in the WAS were observed.