Wrinkling during Cup Drawing with NUMISHEET2014 Benchmark Test. Issue 8 (12th May 2015)

• Record Type: Journal Article
• Authors: Dick, Robert E.; Yoon, Jeong Whan; Whan Yoon, Jeong; Hodgson, Peter; Beynon, John
• Is Part Of: Steel research international. Volume 86:Issue 8(2015:Aug.)
• Page Start: 915
• Page End: 921
• Publication Date: 2015-05-12
• Subjects: Steel -- Periodicals; Steel -- Metallurgy -- Periodicals; 669.142
• DOI: 10.1002/srin.201500018
• Languages: English
• ISSNs: 1611-3683

Abstract

<abstract abstract-type="main" xml:lang="en"> <title> <x xml:space="preserve">Abstract</x> </title> <sec id="srin201500018-sec-0001" sec-type="section"> <p>Wrinkling occurs when a blank is subjected to compressive stresses during the forming process as in the flange of a cup during drawing. Although the failure limit due to plastic flow localization can be simply defined by the FLC at each point of a continuum, the wrinkling limit cannot be defined with simple variables such as strain, stress, and thickness. Wrinkling is strongly affected by the mechanical properties of the sheet material, the geometry of the tools and blank, and contact conditions. The analysis of wrinkling initiation and growth is, therefore, difficult to perform due to the complex synergistic effects of the controlling parameters. Because of these difficulties, the study of wrinkling has generally been conducted case by case. A unique wrinkling criterion, which could be used effectively for various sheet forming processes, has not yet been proposed. There were many investigations on the effect of process parameters (BHF and friction) and geometry on wrinkling. However, there are few reported results on the influence of the material model on wrinkling. This paper shows how strain hardening and <italic>r</italic>‐values affect wrinkle formation in its magnitude, initiation, and direction through the NUMISHEET2014 benchmark test for wrinkling during cup drawing.</p> </sec> </abstract>